Determining the manufacturer of the output shaft
NOTE:
TECHNICAL INFORMATION
The bellows of the wheel-side joint must not be replaced individually by the manufacturer Neapco for output shafts.
The bellows of the wheel-side joint must not be replaced individually by the manufacturer Neapco for output shafts.
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
Check
- Determine the dimension (A) of the bellows (1) at the transmission end.
Result
» Dimension (A) = 106 mm (Manufacturer Neapco)
Measure
- Bellows (1) at the transmission end must not be replaced individually in the case of output shafts by the manufacturer Neapco.
Result
» Dimension (A)= 126 mm
Measure
- Bellows (1) at the transmission end may be replaced individually.