Fastening the wiring harness to the M Sport differential
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Connect connectors (1) and lock.
- Secure the cables on the holders (2)
.
- Position the ground strap (2) on the rear axle differential.
- Tighten down screw (1)
.TIGHTENING TORQUE SPECIFICATION
Ground strap on rear axle differential M6x20 tightening torque 8 Nm - Position the heat shield (2) .
- Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATION
Heat shield to servomotor M5x10 tightening torque 5 Nm