Install the electrical auxiliary coolant pump for the charge air cooler or the air conditioning condenser

• Feed in and position the electrical auxiliary coolant pump (4).
• Insert and install the holder (2).
• Tighten nut (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Electric coolant pump to holder
  M6	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (3) and lock.

  The connector (3) must engage audibly.

  NOTE: TECHNICAL INFORMATION 
  Make sure that the connections are locked correctly. The locks must engage audibly.
• Connect and lock coolant lines (1) and (2).

  The coolant lines (1) and (2) must audibly engage.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .