Installing the electric coolant pump for the charge air cooler and the air conditioning condenser

• Position electric coolant pump (3)  .
• Connect and lock the connector (2)  .
• Make sure the connector (2)  engages audibly.
• Connect and lock coolant line (1)  .
• Make sure that the coolant line (1)  engages audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and install the retainer (1)  .
• Make sure the retainer (1)  is correctly  positioned on the bracket (2)  .
• Tighten nut (3)  .
  TIGHTENING TORQUE SPECIFICATION
  
  

  Electric coolant pump to holder
  M6
  	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock coolant line (1)  .
• Make sure that the coolant line (1)  engages audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING HEAT MANAGEMENT MODULE .
• Refer to INSTALLING THE INTAKE PLENUM .
• Refer to INSTALLING THE TANK VENT VALVE .
• Refer to INSTALLING CONTROL UNIT BRACKET .
• Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
• Refer to INSTALLING THE DME CONTROL UNIT .
• Refer to INSTALLING INTAKE FILTER HOUSING .
• Refer to INSTALLING THE RIGHT FRONT-END STRUT .
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
• Refer to EVACUATING AND CHARGING CONDITIONING .
• Refer to FILLING AND VENTING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to FILLING AND VENTING THE LOW-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING ACOUSTIC COVER AT REAR .
• Refer to INSTALLING THE REAR HOOD SEAL .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to TAKING HOOD OUT OF THE SERVICE POSITION .