Removing transmission oil cooler
Preliminary work
- Refer to REMOVING SEAL FOR FRONT HOOD .
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to REMOVING THE LEFT AND RIGHT FRONT-END STRUT .
- Refer to IF INSTALLED: PARTIALLY REMOVING THE TOP RIGHT AND LEFT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING UPPER CROSS CONNECTION .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Refer to REMOVING THE FAN COWL .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THRUST FIELD .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to IF INSTALLED: REMOVING THE ENGINE OIL COOLER .
- Refer to DRAINING THE COOLANT FROM THE LOW-TEMPERATURE COOLING SYSTEM .
- Refer to REMOVING THE RADIATOR OF THE LOW-TEMPERATURE COOLANT CIRCUIT .
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Loosen screws (1).
- Unlock the lock (1) in arrow direction with a standard screwdriver (2).
- Feed the cover (3) out to the bottom and remove.
- For better accessibility:
Tilt and position the cooling module (1) in the arrow direction.
- Unlock lock (1).
- Guide the stone chip guard (2) in direction of arrow out of the brackets (3) and remove.
- Tilt and hold the cooling module (1) for a better accessibility in the arrow direction.
- Unlock the transmission oil line (1) at right and disconnect from transmission oil cooler (3).
- Catch and dispose of escaping transmission oil.
- Unlock the transmission oil line (2) at left and disconnect from the transmission oil cooler (3).
- Catch and dispose of escaping transmission oil.
- Unlock lock (1).
- Feed out the transmission oil cooler (2) from the bracket (3) in direction of the arrow and set it aside.
- Feed out the transmission oil cooler (1) from the holder (2) and the transmission oil line (3) in the direction of the arrow.
- Feed out the transmission oil cooler (1) in arrow direction and remove.