Installing the power distribution box for the positive battery cables at the rear
- Position power distribution (4) correctly and engage the detent (arrow).
- Connect connectors (3) and lock.
- Position the rear positive battery cables and tighten nuts (2).
tightening torque specification
| Positive battery cable | ||
|---|---|---|
| Positive pole screw | Tightening torque | 15 nm |
- Close the cover (1).
Follow-up work
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to IF INSTALLED: INSTALLING THE EMERGENCY WHEEL .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48V ELECTRICAL SYSTEM .