Attaching highly integrated electrified drive topology to the assembly jig
CAUTION:
Tipping hazard
Injury hazard!
Injury hazard!
- Place the electric drive unit in the center on the engine support bracket.
- Before assembly
, position the electric drive unit (1) on 0 495 187 (00 2 300)
special tools 2 413 082
and 0 495 198 (00 2 322)
as follows:
- 2 413 082 and screw 0 495 198 (00 2 322) together so that the left (2) 2 bores and right (3) 4 bores can be seen.
- Mount 5 A1B E90 onto the suspended electric drive unit (3).
- Hand-tighten the screws (1).
- 2 455 010 Mount on 5 A1B E90 .
- Hand-tighten the screws (2).
- 2 413 082 Attach to the 0 495 187 (00 2 300) .
- 2 455 010 Attach to the 2 413 082 .
- Tighten the screws (1).
- Tighten the screws (2).
- 5 A2B A98 and remove 2 456 428 from the highly integrated electrified drive topology (3).