When replacing the alternator: Remounting the belt tensioner of the alternator
- Remove screws (arrows).
- Feed out and remove the belt tensioner of the alternator (1) .
- Make sure that the special tool 0 496 268 (11 0 390)
is fitted correctly.
- Replace alternator.
Parts: Alternator
- Feed in and install the belt tensioner of the alternator (1) .
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATION
| Belt tensioner to alternator/starter motor generator | ||
|---|---|---|
| M8X30 | Tightening torque | 28 Nm |
- Make sure that the special tool 0 496 268 (11 0 390) is fitted correctly.