Remove rubber window seal
WARNING:
Working on 12 V electrical system
.
Risk of short circuits! Risk of fire!
Risk of short circuits! Risk of fire!
- Make sure that there is no charger connected to the jump start terminal in the engine compartment.
- Detach battery ground lead from battery.
- For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Preliminary work
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING FRONT DOOR TRIM PANEL .
- Refer to REMOVING THE MIRROR TRIANGLE .
- Refer to REMOVING EXTERIOR MIRROR .
- Refer to REMOVING OUTER WINDOW CHANNEL STRIP .
- Refer to REMOVING THE WINDOW CHANNEL STRIP (FRONT) ON THE FRONT DOOR .
- Refer to RELEASING THE FRONT DOOR WINDOW GLASS .
- Refer to REMOVING THE MODULE BRACKET FROM THE FRONT DOOR .
- Refer to REMOVING FRONT DOOR WINDOW GLASS .
- Release the clip (1) .
- Release the rubber window seal (2)
at the clip (3)
.
- Release the rubber window seal (2)
at the clips (1)
.
- Feed the rubber window seal (1) out of the window guide rail (2) .
- Carefully feed the rubber window seal (1) out of the door upwards and remove.