Installing the brake pedal travel sensor

• Install the tappet (2).
• Replace nut (1).

  Parts:  Nut

• Tighten nut (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Brake pedal travel sensor to driver tappet
  Nut M6 Replace nut.	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check the O-ring (3) for damage and replace if necessary.
• Install holder (1).
• Tighten the screws (2).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Brake pedal travel sensor to holder
  M5X10 screw	Tightening torque	5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the bolts (1) correctly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the brake pedal travel sensor (2).
• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Brake pedal travel sensor with holder to bearing support
  Oval-head screw	Tightening torque	3.3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .
• Refer to CONNECTING THE DIAGNOSTIC SYSTEM/EXECUTING THE SERVICE FUNCTIONS .