Installing the engine of the hydraulic unit

• Position the engine (3) of the hydraulic unit.

  Make sure that the cable outlet is aligned in the direction of the hydraulic lines.

• Tighten the screws (2).
• Connect connectors (1) and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten the cover cap (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position coating (2) made of foam material.
• Attach adhesive tapes (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Position control unit (2).
• Attach retaining strap (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide in and position hydraulic unit (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to RECONNECTING ALL BATTERY GROUND LEADS .
• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
• Refer to INSTALLING THE TOP LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .