Installing the hydraulic unit

• Protect the working area from escaping hydraulic fluid.
• Insert the hydraulic lines into the locking plate (2) as marked and insert the hydraulic unit.
• Shift the locking plate (2) in the arrow direction.
• Tighten down screws (1).
• Connect the hydraulic unit with all connectors and store level in the luggage compartment.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect all connectors (1) and lock.
• Close trunk.
• Open and close convertible top completely twice.

  Courtesy of BMW OF NORTH AMERICA, INC.

  Check 

• Store the hydraulic unit (1) level.
• Open and close convertible top at least 2 times.
• With the convertible top closed, check if the oil level is within the mark on fluid tank (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» Oil level outside of the mark (2).

Measure 

• Open lid (3) and correct the oil level.

• Position coating (2) made of foam material.
• Attach adhesive tapes (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position control unit (2).
• Attach retaining strap (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the hydraulic unit (1) and position in the correct installation position upwards with the fluid tank.

Courtesy of BMW OF NORTH AMERICA, INC.

• Ensure that the hydraulic unit (1) is installed with the lid (2) towards the top.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
• Refer to INSTALLING THE TOP LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .