Installing the headlining (lowered)

Precondition 

The front seats have been fully adjusted towards the bottom.

The front seat backrests have been fully adjusted towards the rear.

The rear seat backrest is folded down toward the front.

• Install the end support of the sun visors (1) in the headlining and mount it with clamps (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check the clips (1) on the headlining for damage.

  Defective or missing clips (1) must be replaced.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the headlining (1) with the help of an auxiliary person onto the respective edge protection.
• Clip in headlining (1) on the clips (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure expanding rivet (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to TRIM OF THE 3RD INSTALLING THE BRAKE LIGHT .
• Refer to INSTALLING B-PILLAR TRIM PANEL .
• Refer to INSTALLING REAR TRIM PANEL .
• Refer to INSTALLING THE INNER DOOR SILL COVER STRIP .
• Refer to INSTALLING C-PILLAR TRIM PANEL .
• Refer to INSTALLING BACKREST SIDE SECTION .
• Refer to INSTALLING THE REAR SEAT .
• Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
• Refer to INSTALLING THE SUN VISOR AND THE COUNTER SUPPORT .
• Refer to INSTALLING A-PILLAR TRIM PANEL .