Remove the guide for the rear bumper panel on the side
Preliminary work
- Refer to IF INSTALLED: REMOVING THE LANE CHANGE WARNING SENSOR .
- Refer to IF INSTALLED: REMOVING EMERGENCY HORN (ADDITIONAL WORK FOR ANTI-THEFT ALARM SYSTEM) .
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Loosen nuts (1).
- Open the lock (1).
- Unclip the clips (2) of the vehicle wiring harness and the place the wiring harness aside.
- Remove the guide (3) for the rear bumper cover on the side.