41 33 040 Replacing Front Left Or Right Side Wall Holder (4' Series Coupe, Convertible, And Gran Coupe Sedan)

General information: 

Procedure OBSERVE repair stage 2!

Following new body parts are required (refer to Electronic Parts Catalog):

1. Holder, side wall, front (variant 1)
2. Holder, side wall, front (variant 2)

Following CONSUMABLES are required:

Material	Quantity
Adhesive K5a	1
Blind rivets N3	2
Cleaning agent R1	1

Courtesy of BMW OF NORTH AMERICA, INC.

Removal of side wall holder (variant 1): 

Release welded connections in areas (1) and remove holder (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part: 

Adjust new part in conjunction with side panel in front to fit.

In area of bonding surfaces (1), set 2 4.2 mm dia. bores (2) for blind rivets N3.

Remove new part and deburr holes.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation of side wall holder: 

Clean all bonding surfaces with cleaning agent R1.

Apply adhesive to bonding surfaces.

Install new part and rivet with blind rivets.

Removal of side wall holder (variant 2): 

Release welded connection in area (1) and remove holder (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part: 

Fit in new part.

In area of adhesive surface (1), drill a 4.2 mm dia. bore (2) for blind rivet N3.

Remove new part and deburr holes.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation of side wall holder: 

Clean all bonding surfaces with cleaning agent R1.

Apply adhesive to bonding surface.

Install new part and rivet with blind rivet.