Installing the drivetrain for the glass slide/tilt roof panel
Precondition
The glass slide/tilt roof panel is closed.
- Guide in drivetrain (3) for the glass slide/tilt roof panel and position it correctly.
- Connect and lock all connectors (2) .
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Drive motor for panorama glass roof to body | ||
| Screw | tightening torque | 5.5 Nm |
Follow-up work
- Refer to INSTALLING THE HEADLINING (WITH SLIDING/TILTING SUNROOF) (LOWERED) .
- Refer to INSTALLING D-PILLAR TRIM PANEL ON LEFT AND RIGHT .
- Refer to INSTALLING COVER OF THE LUGGAGE COMPARTMENT SIDE SHELF LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AND RIGHT C-PILLAR TRIM PANEL .
- Refer to INSTALLING THE GRAB HANDLE AT THE REAR LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AND RIGHT B-PILLAR TRIM PANEL PARTIALLY .
- Refer to INSTALLING INTERIOR ROOF LIGHT .
- Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
- Refer to INITIALIZING THE GLASS SLIDE/TILT SUNROOF .
- Refer to INSTALLING THE SUN VISORS AND COUNTER SUPPORT ON THE LEFT AND RIGHT .
- Refer to INSTALLING A-PILLAR TRIM PANEL, LEFT AND RIGHT .