Insert top automatic air flap control
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
NOTE:
The operations shown only for one side must be carried out on both sides.
- Mounting the top air flap control (1).
- Connect and lock the respective connectors.
- Guide in the top air flap control (1) and connect it to ball head (2).
- Tighten the screws (1).TIGHTENING TORQUE SPECIFICATION
Air flap control on front end Oval-head screw with spring washer tightening torque 4 Nm - Clip in the cable for the acceleration sensor with holder (2) and feed it into guide (3).
- Connect connectors (1) and lock.
- Guide in cover (2) from the bottom and clip it in with detent (1).