Installing the airbag sensor on the B-pillar
- Place the airbag sensor (3) on the B-pillar and position correctly.
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATION
| Airbag sensor, B-pillar | ||
|---|---|---|
| M6 screw | tightening torque | 8 Nm |
- Connect connectors (1) and lock.
Follow-up work
- Refer to INSTALLING REAR TRIM PANEL .
- Refer to INSTALLING BACKREST SIDE SECTION .
- Refer to INSTALLING THE REAR SEAT .
- Refer to INSTALLING C-PILLAR TRIM PANEL .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .