Installing the idrive controller
- Position the idrive controller (2) on the control unit (3) and snap-in at the detents (arrows).
- Tighten down screws (1).
tightening torque specification
| Controller to gws | ||
|---|---|---|
| Screw | Tightening torque | 1.8 nm |
Follow-up work
- Refer to INSTALLING THE OPERATING FACILITY IN THE CENTER CONSOLE .
- Refer to INSTALLING THE CENTER CONSOLE TRIM .
- Refer to INSTALLING TRIM IN STORAGE COMPARTMENT OF CENTER ARMREST .
- Refer to ENCODING/PROGRAMING CONTROL UNIT(S) .