Shifting the electric drive unit from the installation position
- Release and remove the special tool 0 496 080 (33 5 206) from the loop (3) and the component carrier (4).
- Secure the wiring harness (2) at the position (1).
- Slacken the chains of special tool 0 490 579 (11 0 070) by turning special tool 2 361 506 (00 6 103) .
NOTE:
Perform the steps on the left and right side.
- While lowering the electric drive unit, observe the correct position of the rubber mount (1) in relation to the engine support bracket (2).
NOTE:
Perform the steps on the left and right side.
- Replace the screw (1).
Parts: Screw
- Tighten the screw (1) on the engine support bracket (2).
- Detach the special tool 0 490 579 (11 0 070)
from the loop (1).
- Detach the special tool 0 490 579 (11 0 070) from the loop (1).
NOTE:
TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.
Conduct the following operation with the assistance of a second person.
- Remove special tool 0 496 852 (00 6 100) .
Follow-up work
- Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to SECURING THE BEARING BRACKET ON THE LEFT .
- Refer to SECURING THE BEARING BRACKET ON THE RIGHT .
- Refer to INSTALLING THE LEFT STRUT .
- Refer to INSTALLING THE RIGHT STRUT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT THE TOP REAR .
- Refer to INSTALLING THE LATERAL HOOD SEALS .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT THE TOP REAR .
- Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP .
- Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .