Installing knock sensor of cylinders 1 to 3
- Clean the contact surface of the knock sensor at the crankcase.
- Feed in and install the knock sensor (3).
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATION
| Knock sensor to crankcase | ||
|---|---|---|
| M8x30 | Tightening torque | 21.5 Nm |
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
- Feed in and install the support (2) for the intake plenum.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATION
| Support to cylinder head | ||
|---|---|---|
| M6X16 | tightening torque | 8 Nm |
- Secure clamps (1).
- Secure clamps (2).
Follow-up work
- Refer to INSTALLING THE INTAKE PLENUM .
- Refer to INSTALLING THE TANK VENT VALVE .
- Refer to INSTALLING CONTROL UNIT BRACKET .
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to INSTALLING THE DME CONTROL UNIT .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to FILLING AND VENTING THE LOW-TEMPERATURE COOLANT CIRCUIT .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .