Installing the control unit for the Front Light Electronics Right (FLER)

NOTE: Description is for left component only. Procedure on the right side is identical.

Check the seal (3) on the control unit (2) for damage and replace as needed.
Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the control unit (2) in the headlight.
Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATION

Frontal Light Electronics (FLE)
PT-SCREW 40x12	tightening torque	1.5 Nm

G15530720

Courtesy of BMW OF NORTH AMERICA, INC.

G15530720

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to PROCESSING THE LED HEADLIGHT SERVICE TEST MODULE .