Install the stiffening plate
- Position thrust field (3).
- Replace screws (2).
Parts: Screws
- Screw in the screws (2) by a few turns.
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATION
| Thrust field to reinforcement strut | ||
|---|---|---|
| M10x16 | Tightening torque | 56 Nm |
- Tighten the screws (2).
TIGHTENING TORQUE SPECIFICATION
| Thrust field to front axle support | ||
|---|---|---|
| M10x25 Replace screws. Screw in all the screws by several rotations . |
Tightening torque | 56 Nm |
| Angle of rotation | 90° | |
Follow-up work
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .