Install control unit bracket

• Make sure the control unit bracket (1) at bottom is fed into the mount (2) correctly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the control unit bracket (2) and install.
• Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and install the cable clip (1).

  The lock (arrow) must audibly engage.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure clamps (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and install the cable bracket (2).

  The locks (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the connector (2) on the control unit bracket (3).

  The connector (2) must engage audibly.

• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the connector (2) to the control unit bracket (3) and lock.

  The connector (2) must engage audibly.

• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

• Secure the clamps (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
• Refer to INSTALLING THE DME CONTROL UNIT .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to RECONNECTING ALL BATTERY GROUND LEADS .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .