Tighten the screw connection on the rear axle support
NOTE:
TECHNICAL INFORMATION
Tighten the screw connection in the NORMAL POSITION .
Tighten the screw connection in the NORMAL POSITION .
- Release nut (1) and tighten it by a turn. Provide counter support to the eccentric screw in the process.
TIGHTENING TORQUE SPECIFICATION
| Camber control arm to rear axle support | ||
| M14 Replace the eccentric screw, nut, and eccentric washer. Tighten in normal position. |
tightening torque | 175 Nm |