Install vibration absorber on the rear axle differential
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
Install vibration absorber on the rear axle differential
- Position the vibration absorber (1).
- Replace the screw (2).
Parts: Screw
- Position and tighten the screw (2).
TIGHTENING TORQUE SPECIFICATION
| Vibration absorber at rear axle | ||
| M8 Replace screw. |
Tightening torque | 28 Nm |
TIGHTENING TORQUE SPECIFICATION
| Vibration absorber at rear axle | ||
| M10 Replace screw. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |