Adjust the striker on the hood

Check 

• Check the gap dimensions between the hood and the adjoining components.

Courtesy of BMW OF NORTH AMERICA, INC.

Gap dimension from hood to bumper cover
1 hood; 2 bumper cover Courtesy of BMW OF NORTH AMERICA, INC.	a	3.5 +1.2-1.2 mm
	b	1.0 +1.5-1.5 mm

Gap dimension hood to headlight
1 hood; 2 headlight Courtesy of BMW OF NORTH AMERICA, INC.	a	5.3 +1.8-1.8 mm

Gap dimension hood to side panel
1 hood; 2 side panel Courtesy of BMW OF NORTH AMERICA, INC.	a	3.3 +1-1 mm
	b	0.5 +1.6-1.6 mm

Result 

» Gap dimensions do not correspond to the specifications.

Measure

• Adjust the striker.

• Adjust striker (2) by turning nut (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting hood stop pads 

• Screw in stop pads (1) fully until the pin (2) can be pulled out.

  Pull pin (2) out approx. 5 mm.

• Slowly close the hood. The pin (2) will be pressed into stop pad (1) while doing so.
• Raise hood.
• Unscrew stop pad (1) until stop pad is flush with upper edge of pin (2).

Courtesy of BMW OF NORTH AMERICA, INC.