Removing rain-light-solar-condensation sensor
- Press in the retaining springs (1) on both sides in the arrow direction and unlock the lock by means of a screwdriver (2) in the arrow direction.
NOTE:
RISK OF DAMAGE
Damage to silicone surface.
A damaged silicone surface can lead to malfunctioning of the rain-light-solar condensation sensor.
Damage to silicone surface.
A damaged silicone surface can lead to malfunctioning of the rain-light-solar condensation sensor.
- Do not tap or damage the silicone coated surface on the rain-light-solar condensation sensor.
- After loosening lock, wait approx. 30 min. at 20°C for silicone surface to relax.
- Pull the rain-light-solar-condensation sensor (3) slowly off the windshield. In the process, pay attention from outside to the loosening of the silicone surface.
The silicone surface must evenly loosen from the windshield; if necessary, pull off slower.
- Guide out rain-light-solar-condensation sensor (3) from the holder.
When replacing the windshield, the rain-light-solar condensation sensor must be installed on the new windshield.