Installing the front strap fitting
NOTE:
TECHNICAL INFORMATION
Clean all belt fittings with microencapsulated male and female threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength .
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all belt fittings with microencapsulated male and female threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength .
The screw connection must be completed within 10 minutes as hardening begins after this period.
- Clip in the cover (2) of the seat belt end fitting (3) in arrow direction in the seat belt end fitting (3).
- Slide the sleeve (1) in the cover (2) of the seat belt end fitting (3).
- Position the seat belt end fitting correctly.
- Tighten down screw (2).TIGHTENING TORQUE SPECIFICATION
End lining to body M10 Tightening torque 42 Nm - Clip in the cover cap (1).