Installing left and right hood lock

Installing the right hood lock

Attach the cable (3).
Feed in the hood lock.
Replace screws (2).
Parts: Screws

Tighten down screws (2).

TIGHTENING TORQUE SPECIFICATION

Hood lock
screw Replace screws	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock.

Attach the cable (3).
Feed in the hood lock.
Replace screws (2).
Parts: Screws

Tighten down screws (2).

TIGHTENING TORQUE SPECIFICATION

Hood lock
screw Replace screws	Tightening torque	8 Nm

Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Only on vehicles with active pedestrian protection

Activate electrical system

NOTE: TECHNICAL INFORMATION
The vehicle-specific specifications described in the further information must be followed!

Activate the vehicle electrical system according to the specifications described in the following information.

Courtesy of BMW OF NORTH AMERICA, INC.

Activating the 48 V electrical system

Precondition

Ignition is switched off.

NOTE: RISK OF DAMAGE
Damage to the 48-V battery
If a 48-V battery that is disconnected from the electrical system is activated, the battery electronics will be damaged.

Only ever activate the 48 V electrical system when the 48 V battery is fully connected up.

Raise the battery ground cable.
Remove special tool 2 452 007.

Courtesy of BMW OF NORTH AMERICA, INC.
Release the negative battery cable of the 48-V battery from the attachment.
Position the negative battery cable of the 48-V battery on the negative battery terminal.
Tighten nut.

TIGHTENING TORQUE SPECIFICATION

Negative battery cable to 48-V battery
Nut M8	tightening torque	19 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect the connector of the CAN bus and lock it.
Clip in clip.

Courtesy of BMW OF NORTH AMERICA, INC.
Activate the 48 V electrical system by closing the hood.
Activation is automatic.

Courtesy of BMW OF NORTH AMERICA, INC.