Install left and right rear side trim panel
NOTE:
Description is for left component only. Procedure on the right side is identical.
Install rear trim panel
- Check whether the clips (1) are present and have damage.
Damaged or missing clips (1) must be replaced.
- Install the side trim panel and in this process insert the safety belt.
- Connect all connectors (1) and lock.
- Position side trim panel (1) correctly and guide it into the edge protection carefully.
- Clip side trim panel (1) into clamps (2).
- Clip side trim panel (1) into clips (3).
- Tighten screws (1) and (2).TIGHTENING TORQUE SPECIFICATION
Side finisher panel, rear Cheese head screw
(sheet metal screw)Tightening torque 3.2 Nm M6x25 screw Tightening torque 3.2 Nm - Tighten down screw (1).TIGHTENING TORQUE SPECIFICATION
Side finisher panel, rear Cheese head screw
(sheet metal screw)Tightening torque 3.2 Nm M6x25 screw Tightening torque 3.2 Nm - Tighten down screw (1).TIGHTENING TORQUE SPECIFICATION
Rear side trim panel (on the seat-belt extender) Torx bolt Tightening torque 1.8 Nm - Install the cover (1).
Installing seat belt extender hand
NOTE:
TECHNICAL INFORMATION
Clean all belt fittings with microencapsulated male and female threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all belt fittings with microencapsulated male and female threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
NOTE:
To provide a better overview:
Schematic diagram with partially hidden components.
Schematic diagram with partially hidden components.
- Thread the shoulder belt (3) into the seat belt extender hand (1).
- Carefully feed the seat belt extender hand (1) into the seat belt extender (2) in the arrow direction.
Installing the front strap fitting
NOTE:
TECHNICAL INFORMATION
Clean all belt fittings with microencapsulated male and female threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all belt fittings with microencapsulated male and female threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
- Clip in the cover (2) of the seat belt end fitting (3) in arrow direction in the seat belt end fitting (3).
- Slide the sleeve (1) in the cover (2) of the seat belt end fitting (3).
- Position the seat belt end fitting correctly.
- Tighten down screw (2).TIGHTENING TORQUE SPECIFICATION
End lining to body M10 Tightening torque 42 Nm - Clip in the cover cap (1).