Install the front output shafts (on the mobile lifting table)

NOTE: TECHNICAL INFORMATION
If the driven shaft is reused, the circlip must be replaced.

NOTE: TECHNICAL INFORMATION
Extreme force being required during installation is an indication that the component is damaged or deformed.
Check component and replace if necessary.

Check the gearing of the output shaft for damage and replace damaged parts if necessary.
Check the bellows for damage and replace damaged parts as needed.
Replace the circlip (1).
Parts: Circlip
Coat the contact surfaces (2) using approved rear differential fluid.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The figure shows the procedure for the front axle differential. The procedure for the bearing bracket is identical.
Fold open the assembly protection ring (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (2).
Remove the swivel bearing mount (1) and set it aside.
Suspend the swivel bearing from the workshop crane 2 220 718.

Courtesy of BMW OF NORTH AMERICA, INC.
Tilt the swivel bearing (2) slightly forward in the arrow direction.
Insert the output shaft (3) into the front axle differential all the way to the stop until you feel the output shaft snap-in.

Tighten screw (1) with the special tool 0 490 504 (00 9 120).

TIGHTENING TORQUE SPECIFICATION

Output shaft to wheel bearing
M16 Replace collar screw and spring.	Joining torque	210 Nm
	Angle of rotation	90°

Courtesy of BMW OF NORTH AMERICA, INC.

Pull on the tab of the installation protection ring (1) until one of the two predetermined breaking points breaks.
Pull out and dispose of the installation protection ring (1).
Push the output shaft (2) up to the stop in the front axle differential or the bearing bracket.
The output shaft (2) must snap in noticeably and audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Install the stand (2) of the swivel bearing (3).
Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Position the anti-roll bar link (2) on the spring strut.
Replace nut (1).
Parts: Nut

Tighten the nut (1), if necessary, counter support the Torx socket.

TIGHTENING TORQUE SPECIFICATION

Front anti-roll bar link to anti-roll bar/spring strut
M10 Replace nut.	tightening torque	56 Nm

Courtesy of BMW OF NORTH AMERICA, INC.