Remove engine ventilation line
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING RIGHT FRONT-END STRUT .
- Refer to REMOVING INTAKE SILENCER HOUSING .
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
RISK OF DAMAGE
Damage to wires when disconnecting connectors and plug connections.
Sheared wires can cause a short circuit.
Damage to wires when disconnecting connectors and plug connections.
Sheared wires can cause a short circuit.
- Do not pull on wires when disconnecting connectors and plug connections.
- Unlock the locks (1).
- Feed out the heat protection ring (2) and remove.
- Unlock plug connection (1) and disconnect.
- Unlock plug connection (2) and disconnect.
- Loosen clamp (3).
- Guide out the wiring harness section for the sensor system 2
(4) and set side.
- Unlock and loosen the locks (1).
- Unlock and loosen lock (2).
- Feed the engine ventilation line (3) out and set it aside.
- Unlock and release tank vent line (1).
- Feed out the engine ventilation line (2) and remove.