Install engine ventilation line

NOTE: RISK OF DAMAGE
Improper routing of cables and wiring harnesses.
Trapped, crushed or damaged cables may cause short circuits and malfunctions.

NOTE: TECHNICAL INFORMATION
Check the retaining lug on the connector for damage and perform a tension check as needed.

Check the sealing ring (1) for damage and replace the tank ventilation line if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and position the engine ventilation line (2).
Insert and install the tank vent line (1).
The tank vent line (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install the engine ventilation line (3).
Make sure that the locks (1) and (2) snap-in audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in and position the wiring harness section of sensor system 2 (4).
Connect connectors (2) and lock.
Connect connectors (1) and lock.
The connectors (1) and (2) must engage audibly.
Secure clamps (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in and install the heat protection (2).
Lock the locks (1).
Locks (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work