Removing belt tensioner of alternator
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING SEAL FOR FRONT HOOD .
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to IF INSTALLED: PARTIALLY REMOVING THE TOP RIGHT AND LEFT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING THE LEFT AND RIGHT FRONT-END STRUT .
- Refer to REMOVING UPPER CROSS CONNECTION .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING CLEAN AIR PIPE .
- Refer to REMOVING THE FAN COWL .
- Refer to REMOVING CHARGE AIR LINE .
- Refer to REMOVING THE DRIVE BELT FOR ALTERNATOR .
CAUTION:
Component with preload
.
Injury hazard!
Injury hazard!
- Reduce preload as far as possible before disassembly. Relieve component.
- Using a standard tool (1), increase the preload on the alternator belt tensioner by turning it in the direction of the arrow .
- Guide the special tool 0 496 268 (11 0 390) out and remove.
- Remove screws (arrows).
- Remove belt tensioner of the alternator (1).