Installing the corner part of the bumper guide
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Position the corner part of the bumper guide.
- Tighten nuts (1).TIGHTENING TORQUE SPECIFICATION
Guide lateral support on body Combination hexagon nut tightening torque 4.6 Nm - Clip in the wiring harness (1) with the holders (2).
Follow-up work
- Refer to INSTALLING THE REAR BUMPER COVER .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
- Refer to INSTALLING THE TRIM IN THE WATER CHANNEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .