Installing the support for the rear bumper cover

• Replace seals (1).

  Parts:  Seal

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the support for the rear bumper cover (2).
• Tighten nuts (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• If installed: 
• Position the rear muffler with holder (2) on the left and right on the support for the rear bumper cover.
• Replace nut (1).

  Parts:  Nut

• Tighten the nuts (1) on the left and right.
  TIGHTENING TORQUE SPECIFICATION
  
  

  Rear silencer on support
  M8 hexagon nut	Tightening torque	19 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE BRACE FOR THE REAR BUMPER COVER .
• Refer to INSTALLING THE REAR BUMPER COVER .
• Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
• Refer to INSTALLING THE TRIM IN THE WATER CHANNEL ON THE LEFT AND RIGHT .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .