33 32 Rear Control Arms, Trailing Arms
3332 TIGHTENING TORQUE OVERVIEW
| Camber control arm to rear axle support | ||
| M14 Replace the eccentric screw, nut, and eccentric washer. Tighten in normal position. |
Tightening torque | 175 Nm |
| Camber control arm to wheel earner | ||
| M14 Replace screw and nut. |
Joining torque | 165 Nm |
| Angle of rotation | 90° | |
| Control arm to rear axle support | ||
| M12 Replace screw and nut. Tighten in normal position. |
Joining torque | 100 Nm |
| Angle of rotation | 90° | |
| Control arm to wheel carrier | ||
| M14 Replace screw. Tighten in normal position. |
Joining torque | 165 Nm |
| Angle of rotation | 90° | |
| Control link to rear axle support | ||
| M12 Replace the eccentric screw, eccentric washer and nut. Tighten in normal position. |
Tightening torque | 108 Nm |
| Cover to camber control arm | ||
| M6 Replace nuts. |
Tightening torque | 6 Nm |
| Holder on wheel carrier | ||
| Replace screw. | Tightening torque | 12 Nm |
| Upper wishbone & Track arm to wheel carrier | ||
| M12 Replace screw and nut. Tighten in normal position. |
Joining torque | 100 Nm |
| Angle of rotation | 90° | |
| Trailing arm to rear axle support & wheel carrier | ||
| M12 Replace screw and nut. Tighten in normal position. |
Tightening torque | 100 Nm |
| Upper wishbone to rear axle carrier | ||
| M12 Replace screw and nut. Tighten in normal position. |
Tightening torque | 70 Nm |
| Angle of rotation | 135° | |