Remove The Outer Section Of The B-Pillar

Mark the separating cut (1) in the center through the embossing (2) and separate. Thereby disconnect only the outer panel.

Courtesy of BMW OF NORTH AMERICA, INC.
Mark each of the separating cuts (1) and (2) in the center through the
holes (3) and (4) with Ø 20 mm and separate.

Thereby disconnect only the outer panel.
Open welded connections in area (5).

Courtesy of BMW OF NORTH AMERICA, INC.
Release the welded connections in areas (1).
NOTE: TECHNICAL INFORMATION
For additional information see: 41 00...
Releasing bonded connections
Loosen bonded connections in area (2).
Detach the outer section of the B-pillar from the cavity sealing (3) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.