Preparing New Part
- Mark severance cuts on new part in accordance with severance cuts on vehicle and cut.NOTE: TECHNICAL INFORMATION
For additional information see: 41 00...
Welding in reinforcement plates (sheet steel) - Prepare reinforcement plates at severance cuts.
- Fit in new part.NOTE: TECHNICAL INFORMATION
For additional information see: 41 00...
Spot-weld bonding steel components - Prepare the new part in areas (1) and (2) for joining by welding.
In area (2), observe the procedure for the replacement of spot-welded adhesive joints for the standard production.
Replacing the coarse thread bolt and threaded weld bolts (steel surface)
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Renew the coarse thread bolt (1) and the threaded weld bolt (2).
Parts: Coarse thread bolt, threaded weld bolt
Take the number and position from the component to be replaced or the add-ons.
- Weld the coarse thread bolt (1) and threaded weld bolt (2) onto the new part.