Installing the control unit for the optional equipment system (SAS)
- Position the control unit for optional equipment system (SAS) (1).
- Replace the plastic nuts (3).
Parts: Plastic nuts
- Insert and tighten plastic nuts (3).
TIGHTENING TORQUE SPECIFICATION
| Control unit for the optional equipment system (SAS) to the holder | ||
| Replace plastic nut. | tightening torque | 4 Nm |
- Connect the plug connection (2).
Follow-up work
- Refer to INSTALLING KNEE AIRBAG .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .
- Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .