Installing front brake caliper (high brake)
- Install the brake caliper in the arrow direction.
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATION
| Brake caliper/brake anchor plate at front swivel bearing | ||
| M12 Replace screw. |
Tightening torque | 130 Nm |
- Fit and tighten brake hose (1) on brake caliper.
If necessary, grip at knurling (2).
TIGHTENING TORQUE SPECIFICATION
| Brake hose to brake caliper, front | ||
| tightening torque | 17 Nm | |
- Make sure the brake hose is not twisted and resting on components attached to the body.
- If necessary, hook the brake hose in the holder (3).
Follow-up work
- Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE (BRAKE HIGH) .
- Refer to INSTALLING FRONT PADS (HIGH BRAKE) .
- Refer to ADHESION OF BRAKE PADS TO BRAKE PISTONS .
- Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR (HIGH BRAKE) .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to COMMISSIONING OR BEDDING IN (BRAKE) OF NEW BRAKE PADS AND DISCS (HIGH BRAKE) .