Installing the expansion tank (vehicles with automatic transmission)
- Replace rubber plugs (1).
Parts: Rubber plugs
- Connect expansion tank to the tandem brake master cylinder.
- Replace the retaining screw (1).
Parts: Retaining screw
- Fit and tighten the retaining screw (1).
TIGHTENING TORQUE SPECIFICATION
| Retaining screw, expansion tank to tandem brake master cylinder | ||
| Replace screw. | Tightening torque | 4 Nm |
- Connect connector (1).
- Hook the cable into holder (2).
Follow-up work
- Refer to CONNECTING THE BLEEDER UNIT FOR BRAKE FLUID (AFTER REPAIR, TOPPING UP BRAKE FLUID) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to IF INSTALLED: REMOVING STRUT BRACE IN THE REAR OF THE ENGINE COMPARTMENT .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .