Installing the control unit for the optional equipment system (SAS)

Position the control unit for optional equipment system (SAS) (1).
Replace the plastic nuts (3).
Parts: Plastic nuts
Insert and tighten plastic nuts (3).

TIGHTENING TORQUE SPECIFICATION

Control unit for the optional equipment system (SAS) to the holder
Replace plastic nut.	tightening torque	4 Nm

Connect the plug connection (2).

G14641270

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .
Refer to PROGRAM/ENCODE THE OPTIONAL EQUIPMENT SYSTEM (SAS) .