Install brake booster
- Guide the brake booster (1)
into the firewall.
- Install the nuts (1) and tighten.
- Replace nuts.
Parts: Nuts
TIGHTENING TORQUE SPECIFICATION
| Brake booster to pedal assembly console | ||
| Replace nuts. M8 Retighten 1x on brake booster after 10 min. |
tightening torque | 22 Nm |
- Lock brake pedal (1)
in place in the arrow direction with the brake booster.
Ensure that the brake pedal is completely locked with the brake booster!
- Install the check valve (1)
in the brake booster in the arrow direction.
- Install air duct (1) .
Follow-up work
- Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .
- Refer to INSTALLING THE TANDEM BRAKE MASTER CYLINDER (VEHICLES WITH MANUAL TRANSMISSION) .
- Refer to INSTALLING EXPANSION TANK (VEHICLES WITH MANUAL TRANSMISSION) .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND VENTING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to IF INSTALLED: REMOVING STRUT BRACE IN THE REAR OF THE ENGINE COMPARTMENT .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .