Installing the seal for the rear roof frame
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
CAUTION:
Folding up of convertible top through loss of pressure in hydraulic cylinders
.
Injury hazard! Injury hazard by trapping!
Injury hazard! Injury hazard by trapping!
- When carrying out all repair work, secure soft top and soft top compartment lid with a suitable support tool against collapsing. Ensure soft top is supported in the middle.
- Bring the convertible top (1) in the half opened position.
Secure the convertible top (1) from collapsing by using the support 2 452 010 if necessary.
NOTE:
Perform the steps on the left and right side.
- Position the seal carrier (2) of the seal for the windshield panel.
- Turn in screw (1) several rotations.
- Position the washers (3).
- Align the screws (1) at the previously set marks and tighten them.
TIGHTENING TORQUE SPECIFICATION
| Seal carrier to hood linkage | ||
| Oval-head screw | Tightening torque | 5 Nm |
Follow-up work
- Refer to ADJUSTING DOOR WINDOW GLASS .
- Refer to ADJUSTING THE REAR SIDE WINDOW .