51 64 Front Panel / Front End Trim
5164 TIGHTENING TORQUE OVERVIEW
| Adapter to the front panel | ||
| Oval-head screw with spring washer | Tightening torque | 4 Nm |
| Air flap control on front end | ||
| Oval-head screw with spring washer | Tightening torque | 4 Nm |
| Cross connection, top | ||
| M8x20 M6x20 |
Tightening torque | 8 Nm |
| Cross connection at the front of the lock | ||
| Combination oval-head machine screw | Tightening torque | 8 Nm |
| Front end strut | ||
| screw | Tightening torque | 56 Nm |
| Holder to support | ||
| M6x20 | Tightening torque | 8 Nm |
| Lower air flap control on bumper cover support | ||
| Oval-head screw | Tightening torque | .6 Nm |
| Rear cross connection at the top of the hood latch support | ||
| Flat-head screw M6x20 | Tightening torque | 1.8 Nm |
| Rear top cross connection to wheel arch carrier support | ||
| M10x20 screw Replace screw. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |
| Reinforcement strut on cross connection and bumper bracket | ||
| Hexagon screw M8 | Tightening torque | 28 Nm |