Installing the storage net
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Measure the reference dimension on the template (1) and cut it out as shown.
- As shown, position template (1) on the frame (2) and fasten using adhesive tape.
- Drill holes all the way through at the marks using the ø 6.5 mm drill bit from the special tools 5 A63 022 .
- Remove the template (1).
- Screw the holder (1) into the bores.
- Measure the reference dimension on the template (1) and cut it out as shown.
- As shown, position template (1) on the frame (2) and fasten using adhesive tape.
- Drill holes all the way through at the marks using the ø 10 mm drill bit from the special tools 5 A63 022 .
- Remove the template (1).
- Measure the reference dimension on the template (1) and cut it out as shown.
- As shown, position template (1) on the frame (2) and fasten using adhesive tape.
- Drill holes all the way through at the marks using the ø 10 mm drill bit from the special tools 5 A63 022 .
- Remove the template (1).
- Insert the holder (1) into the bores and lock in place correctly.
- Insert storage net (1) in the holder at the top as pictured and snap it in correctly at the holders at the bottom.
Follow-up work
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
- Refer to INSTALLING LED IN LUGGAGE COMPARTMENT ON RIGHT .
- Refer to INSTALLING COVER FOR LUGGAGE COMPARTMENT ON RIGHT .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING THE FRONT STORAGE SHELF .