51 71 Wheel Arch Covers, Trim Panels
5171 TIGHTENING TORQUE OVERVIEW
| Firewall lower part on body | ||
| screw Plastic nut |
Tightening torque | 2.6 Nm |
| Connecting support to tunnel | ||
| M8x25 screw | Tightening torque | 20 Nm |
| Screw | Tightening torque | 3 Nm |
| Cover, steering unit | ||
| screw | Tightening torque | 3 Nm |
| Cowl upper part to bottom cowl | ||
| Tightening torque | 3 Nm | |
| Lower side cover at front | ||
| Hexagon screw for thermoplastic | Tightening torque | 3 Nm |
| Rear wheel arch cover to bumper cover | ||
| Hexagon screw | Tightening torque | 2.6 Nm |
| Tension strut on firewall | ||
| M10x25 screw | Tightening torque | 56 Nm |
| Tension strut to shock tower | ||
| screw Replace screws. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |
| Wheel arch cover | ||
| screw | Tightening torque | 3 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |
| Wheel arch cover (screws) | ||
| Thermoplastic hexagon screw | Tightening torque | 3 Nm |
| Wheel arch trim panel, front | ||
| Thermoplastic hexagon screw | Tightening torque | 2.6 Nm |