Install the rear side bumper guide

• Mount the bumper guide and clip into the detent (2).
• Tighten nuts (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Rear bumper cover guide on the side of the body
  Nut and washer assembly with paint scrape groove	Tightening torque	5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Rear wheel arch cover on side bumper cover guide
  Hexagon bolt for thermoplastic	Tightening torque	2.6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (2).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Side bumper cover guide on undershield
  Hexagon bolt for thermoplastic	Tightening torque	2.6 Nm

Follow-up work 

• Refer to IF INSTALLED: INSTALLING THE EMERGENCY HORN (ADDITIONAL WORK ON ANTI-THEFT ALARM SYSTEM) .
• Refer to IF INSTALLED: INSTALLING THE LANE CHANGE WARNING SENSOR .